Mercedes-Benz GL-Class 2008 Owners Manual - Manual (Page 43)

42
Getting started
Unlocking
SmartKey
Starter switch
0 For removing SmartKey
1 Power supply for some electrical con-
sumers, such as seat adjustment
2 Ignition (power supply for all electrical
consumers) and driving position
All lamps (except high beam headlamp
indicator lamp and turn signal indicator
lamps unless activated) in the instru-
ment cluster come on. If a lamp in the
instrument cluster fails to come on
when the ignition is switched on, have
it checked and replaced if necessary. If
a lamp in the instrument cluster re-
mains on after starting the engine or
comes on while driving, refer to “Lamps
in instrument cluster” (
୴ page 436).
3 Starting position
i When you switch on the ignition, the indica-
tor and warning lamps (except high beam head-
lamp indicator lamp and turn signal indicator
lamps unless activated) in the instrument cluster
come on. The indicator and warning lamps (ex-
cept high beam headlamp indicator lamp and
turn signal indicator lamps if activated) will go
out when the engine is running. This indicates
that the respective systems are operational.
i If the SmartKey does not belong to the
vehicle, the SmartKey can be turned in the start-
er switch. However, the ignition does not switch
on and the engine does not start.
i
When the SmartKey is removed from the
starter switch and the automatic transmission is
in a position other than P, the automatic trans-
mission automatically shifts to P.
! If the SmartKey cannot be turned in the
starter switch, the battery may not be sufficient-
ly charged.
ț Check the battery and charge it if necessary
(
୴ page 528).
ț Get a jump start ( ୴ page 536).
To prevent accelerated battery discharge or a
completely discharged battery, always remove
the SmartKey from the starter switch when the
engine is not in operation.
164.boo Seite 42 Freitag, 30. März 2007 12:54 12