Mercedes-Benz GL-Class 2008 Owners Manual - Manual (Page 97)

96
Safety and Security
Occupant safety
The LATCH anchors are blended with
covers.
Example, second-row seats
1 Anchorage ring covers
̈ Remove anchorage ring cover 1 from
the seat on which a child seat is to be
installed.
Example, second-row seats
2 Anchors
̈ Install a LATCH type child seat accord-
ing to the manufacturer’s instructions.
Installation of infant and child restraint
system
This vehicle is equipped with tether
anchorages for a top tether strap at the
second-row seat backrest. For installing an
infant and child restraint system at the
third-row seats, use the cargo tie-down
rings in the cargo compartment
(
୴ page 303).
1 Anchorage ring cover
̈ Remove anchorage ring cover 1 from
seat backrest of the seat on which a
child seat is to be installed.
!
Make sure the seat belt for the center seat
can operate freely with a child seat installed.
i Only the rear outer seats can be used for in-
stalling a LATCH type child seat.
For installing a Non-LATCH type child seat use
the vehicle’s seat belt system. Install child seat
according to the manufacturer’s instructions.
164.boo Seite 96 Freitag, 30. März 2007 12:54 12