Mercedes-Benz GL-Class 2008 Owners Manual - Manual (Page 525)

524
Practical hints
Flat tire
Screw-type jack (example illustration)
Scissors-type jack (example illustration)
̈ Vehicles with screw-type jack: Turn
crank
4 clockwise until jack 3 is fully
seated in take-up bracket 2 and the
jack base evenly meets the ground.
̈ Vehicles with scissors-type jack:
Turn ratchet
4 up and down until
jack 3 is fully seated in take-up
bracket 2 and the jack base evenly
meets the ground.
̈ Continue to turn crank/ratchet 4
until the wheel is a maximum of 1.2 in
(3 cm) from the ground.
Removing the wheel
1 Alignment bolt
̈ Unscrew upper-most wheel bolt and
remove it.
̈ Replace this wheel bolt with alignment
bolt
1 supplied with the tool kit
( ୴ page 490).
̈ Remove the remaining wheel bolts.
̈ Remove the wheel.
! Do not place wheel bolts in sand or dirt. This
could result in damage to the bolts and wheel
hub threads.
୴୴
164.boo Seite 524 Freitag, 30. März 2007 12:54 12