Releasing seat belts, Key, smartkey:locking/unlocking, Releasing seat belts locking – Mercedes-Benz SL-Class 2006 Owners Manual User Manual

Page 62

Advertising
background image

61

Getting started

Parking and locking

Releasing seat belts

̈

Press the seat belt release button
(

page 47).

Allow the retractor to completely re-
wind the seat belt by guiding the latch
plate.

Locking

!

Make sure the seat belt retracts fully so
that the seat belt and/or latch plate
cannot get caught or pinched in the
door or in the seat mechanism. This
can damage the seat belt and impair
the effectiveness of the seat belt,
and/or cause damage to the door
and/or door trim panel. Such damage
is not covered by the Mercedes-Benz
Limited Warranty.

Damaged seat belts must be replaced.
Contact an authorized Mercedes-Benz
Light Truck Center.

Warning!

G

To prevent possible personal injury, always

keep hands and fingers away from the door

openings when closing the doors. Be espe-

cially careful when small children are

around.

Before closing doors, make sure that there

is no possibility of someone getting caught

in a door during closing.

Warning!

G

When leaving the vehicle, always remove the

SmartKey or the SmartKey with

KEYLESS-GO* from the starter switch, take

it with you, and lock the vehicle. Do not

leave children unattended in the vehicle, or

with access to an unlocked vehicle. Unsu-

pervised use of vehicle equipment may

cause an accident and/or serious personal

injury.

i

If you hear a warning signal you have
either

ț

forgotten to turn off the lights be-
fore opening the driver’s door

In addition the message

Turn off

lamps

appears in the multifunction

display.

or

ț

tried to turn off the engine while the
gear selector lever is not in P

In addition the message

Gear se-

lector lever to P

appears in the

multifunction display.

Turn off the lights or place the gear se-
lector lever in P.

Advertising