Oldcastle BuildingEnvelope Standard Door and Frame - Manual (Page 17)

D O O R A N D F R A M E
INSTALLATION OF OFFSET HUNG DOOR ON BUTT HINGES
Back-up plates are installed in the door and the frame. Butt hinges should be installed on the door. The door may
or may not be glazed prior to installation of door.
1. Lift door upward until butt hinges align with hinge cutout in frame.
2. Block under door when hinge and cutout are aligned.
3. Attach hinges to frame back-up plates using proper screws (included). There is a slight adjustment available if
location of door prep and frame cut-out is off slightly. Back off on the screws slightly and adjust door to proper
position; then, tighten down screws.
4. Now that the door is hung, it is time for final adjustments and attachment of hardware.
NOTE: If you have not pre-glazed the door, glaze the door before attachment of hardware.
17 MAY 2012
D O O R & F R A M E I N S T A L L A T I O N M A N U A L
Web Address: www.oldcastlebe.com
Phone: 1-866-OLDCASTLE (653-2278)