Oldcastle BuildingEnvelope Standard Door and Frame - Manual (Page 20)

INSTALLATION OF OFFSET HUNG DOOR WITH
STANDARD OVERHEAD CLOSERS
D O O R A N D F R A M E
1. Set door in frame so that door portion of the bottom
pivot is over spindle of frame portion of the pivot.
2. Align door portion of OP-11 above frame portion
and lower door until positive engagement is felt.
NOTE: the bottom pivot is pre-adjusted to provide
3/16" clearance between door top rail and frame
transom bar. For further vertical adjustment see
figure 2 on page 27.
3. When door is properly positioned, secure closer to
door and transom bar per instructions provided with
closer. These closers require the use of offset arms.
CAUTION: Smooth, permanent trouble-free opera-
tion of the door depends on the proper installation
of the closer. A print is furnished in each closer
package to give correct installation procedure.
4. Close door, glaze and adjust as outlined on pages
15 and 27.
20 MAY 2012
D O O R & F R A M E I N S T A L L A T I O N M A N U A L
Web Address: www.oldcastlebe.com
Phone: 1-866-OLDCASTLE (653-2278)