Pridiom Floor and Ceiling PFCM183HX Installation Manual - Manual (Page 6)

5
installation manual
Fig.5-10
Hanging arm
Remove the side board and the grille.(Refer to Fig. 5-10)
(For models 48 and 60, do not remove the grille.)
Fig. 5-11
Side board
Grille
Locate the hanging arm on the hanging screw bolt.
(Refer to Fig. 5-12)(for some of the models 60 do not do this)
Prepare the mounting bolts on the unit.( Refer to Fig. 5-13)
Screw nut
Washer
Hanging
screw bolt
Hanging arm Fig.5-12
20
～
25mm
2 Install the indoor unit.
Hang the unit on the hanging arm by sliding backward. Securely
tighten the mounting bolts on both sides.(Refer to Fig. 5-14)
(some of the models 60 do not do this)
The dimension of the unit 5.3
Mounting bolt
Hanging arm
Hanging
screw bolt
Fig. 5-14
Table 5-1
20mm
6.1 Installation Place
6. OUTDOOR UNIT INSTALLATION
For some of the models 60 please securely tighten the mounting
bolts on both sides.(Refer to Fig5-15).
The outdoor unit should be installed in the location that
meets the following requiements:
Mounting bolt(max.40mm)
Fig. 5-13
8～13mm
INDOOR UNIT
unit：mm
Fig. 5-15
Fig. 5-16
D. Connecting point of
refrigerant pipe
(D.gas side)
Drain point
E. Connecting point of
refrigerant pipe
(E. Liquid side)
G
C
Fig. 5-17
There is enough room for installation and maintenance.
The air outlet and the air inlet are not impeded, and can
not be reached by strong wind.
It must be a dry and well ventilating place.
The support is flat and horizontal and can stand the
weight of the outdoor unit. And will no additional noise or
vibration.
Your neighborhood will not feel uncomfortable with the
noise or expelled air.
It is easy to install the connecting pipes or cables.
Determine the air outlet direction where the discharged
air is not blocked.
There is no danger of fire due to leakage of inflammable
gas.
Hanging
screw bolt
MODEL
12~24
30~36
48
A B D E F G C
990 660 203 505 506 907 200
1280 660 203 795 506 1195 200
60
60
450 680 240 1070 1542 200 1670
450 680 240 1070 1542 200 1670
380 680 285 1070 1613 220 1670