QOMO QRF900 User Manual User Manual

Page 96

Advertising
background image

Copyright © 2008 -2010 All Rights Reserved by QOMO HiteVision.

www.qomo.com

96

Note: The clicker will detect the active class in the closest proximity.

(3)

Set Channel:

If the clicker does not automatically detect the right class you would like to attend, you may manually
set your clicker communication channel to the channel number that the class use. The class channel
number is the main receiver channel number set.

Note: The main receiver channel can be set in the software. Refer to the software channel session.

To set the clicker channel, follow these steps:

1. Under the NoHost screen, press the

Menu/OK” key

to enter into the main menu.

2.

Select “2.SetChannel” submenu or directly press number “2”.

Under the “SetChannel” screen, enter a valid channel number.

(4)

Login to the last same channel class:

To login to the last same channel class, follow these steps:

Under the NoHost screen, press the

Send Key

to directly log into the class you had last logged

into if the channel is not changed.

After successfully logging in, the LCD login screen will show various displays according to the
software activity mode selected. These will be introduced in operation (5). Once the student has
logged in, an assigned registration number will be displayed on the top of LCD screen.

If the login fails, one of the following messages will be displayed:

“Failure!”

Not able to connect to a host at this time.

“Wait to Start!”

The exam is not ready to begin.

“Invalid ID!”

The software is not able to recognize the student ID. Be sure your student

keypad ID is listed in the class the instructor has selected.

(5)

Operations after a successful login:

One of the following LCD screens will display according to the activity mode:

Advertising