Rice Lake RL550 Digital Chair Scale Technical and Operating Instructions - Manual (Page 17)

Rice Lake 550 Digital Chair Scale - Scale Configuration 13
5.1 Programming Mode Menu
Various parameters can be set while in programming mode.
Those parameters are shown in Figure 5-3.
value
P00
DEF
Value
CALIB PROG
FULL
DONE
BAUD
TOFF ATOL ALEN ATOUT UNITS OP
P01 P02 P03 P04
5
3
4
2
0
1
9
8
7
6
96
1152
48
576
288
384
192
144
DISP ROUND ARW LOAD SAL ASTART
P01-0 P02-1 P03-0 P04-1 P00-1
0.0
0.0000
0
0.000
0.00
0.2
1.0
0.5
2.0
10.0
5.0
20.0
0.1
Value Value Value Kg/Lb
Kg
Lb
Value Value Value
TEST
Figure 5-3. Programming Mode Menu Structure
Table 5-1 lists the various display messages and sequence when setting up the scale.
Parameter Description Choices Steps
FULL Full capacity of the scale Value (1000 lb) The display toggles between a numeric value and FULL.
If you don’t want to change the value, press the BMI key to
move to the next setting. Example: from FULL to LOAD. If you
want to change the value, use the following steps.
1. Press the ENTER key to change value starting with
the right most digit.
2. Use the Up/Down arrow keys to increment/
decrement numbers.
3. Press the BMI key to move to the left.
4. Use the Up/Down arrow keys to increment/
decrement numbers.
5. Press the BMI key again to move to the left
6. Use the Up/Down arrow keys to increment/
decrement numbers.
7. When done press the ENTER key to move to the
next parameter (LOAD).
Table 5-1. Configuration Mode Menu