Rice Lake 920i Installation Manual V3.12 - Manual (Page 111)

Appendix 105
5. Start
iRev
and enter monitor mode, then type
BOOT .
6. Use the indicator setup switch to enter setup
mode.
7. Remove the jumper from SW1.
8. From monitor mode, enter the
RESETCONFIGURATION command.
Determine the cause of the startup handler error, make
program corrections, then reload the corrected user
program and test.
10.1.4 Using the XE Serial Command
The XE serial command can be used to remotely query the
920i
for the error conditions shown on the front panel.
The XE command returns a decimal number representing any existing error conditions. For multi-scale
applications, the value returned by the XE command represents all error conditions, if any, present on all
configured scales.
If more than one error condition exists, the number returned is the sum of the values representing the error
conditions (see Table 10-3 on page 105). For example, if both a tare error (TAREERR, 65536) and a truck
database checksum error (ETRUCKERR, 8192) have occurred, the XE command returns the value 73728,
representing the sum of those two error conditions.
Error Code Value Description
VIRGERR 1 Virgin error
PARMCHKERR 2 Configuration checksum error
LOADCHKERR 4 Calibration checksum error
PRINTCHKERR 8 Print format checksum error
ENVRAMERR 16 General NVRAM error
ENVCRC1ERR 32 Setpoint NVRAM data error
ENVCRC2ERR 64
ENVCRC3ERR 128
ENVCRC4ERR 256
ENVCRC5ERR 512
ENVCRC6ERR 1024
ENVCRC7ERR 2056
ENVCRC8ERR 4096
ENVCRC9ERR 8192 Audit trail error
ETRUCKERR 16384 Truck database checksum error
GRAVERR 32768 Gravity calibration error
— 65536 Reserved
TAREERR 131022 Tare checksum error
EACCOVER 262144 Accumulator overflow error
STRINGERR 524288 String program error
— 1048576 Reserved
RTCERR 2097152 Real time clock error
Table 10-3. Error Codes Returned on XE Command