Rice Lake 920i Installation Manual V3.12 - Manual (Page 72)

66 920i Installation Manual
The truck register can be printed to an attached printer
by pressing the
PRINT
key while the Truck Regs
display is shown. The printed register uses the
TRFMT print format (see Section 6.2 on page 61).
NOTE: If a non-zero setpoint password is configured
(SPPWD parameter on the FEATURE menu), you must
enter the password before any truck register entries can be
deleted.
7.3 Weigh-In Procedure
In modes 1 and 2, the indicator erases truck ID
numbers and tare weights from memory after the
transaction. In modes 3–6,the truck ID and weigh-in
weight values are saved after the weigh-out ticket has
been processed.
The general weigh-in procedure is as follows:
1. The empty truck moves onto the scale for
weigh-in.
2. Press the
Weigh In
softkey.
3. A prompt is shown to enter the truck ID (up to
eight alphanumeric characters). Enter the ID,
then press the
enter
key.
4. Indicator generates the weigh-in ticket:
ID 304812
GROSS 15000. LB INBOUND
01/14/2002 10:24 AM
5. Truck leaves the scale.
7.4 Weigh-Out Procedure
The general weigh-out procedure is as follows:
1. The loaded truck moves onto the scale for
weigh-out.
2. If truck ID is known, press the
Weigh Out
softkey, enter the ID, and press the
enter
key.
If ID is not known, press the
Truck Regs
softkey to view list of stored IDs (see
Figure 7-2 on page 65). Scroll to the correct
truck ID, note the ID number, then press the
Cancel
softkey to return to the weight display.
From the weight display, press
Weigh Out
, key
in the ID, then press the
enter
key.
3. Indicator generates the weigh-out ticket. In
modes 1 and 2, the ID is deleted once the
weigh-out ticket is processed.
7.5 Single-Transaction Tare Weights
and IDs
One-time transactions are supported in all modes that
can be configured to use stored IDs (modes 3–6). This
function allows one-time weighing of trucks without
adding the truck ID and weigh-in weight to the
permanent truck register.
To use this function, press the
Weigh In
or
Weigh Out
softkey, then enter a truck ID containing a decimal
point. IDs entered with a decimal point as part of the
ID are erased from the truck register when the
transaction is complete.