2 laserlight commands, 3 default print formats, 2 laserlight commands 6.3 default print formats – Rice Lake 920i Installation Manual V4.01 User Manual
Page 70
64
920i
Installation Manual
6.2
LaserLight Commands
Table 6-2 lists commands to operate the Stop, Go (circle or arrow) and Off display elements on a LaserLight.
These commands are used for front panel softkeys.
Table 6-2. LaserLight Commands
Traffic Light State
Aux Fmt
Dry Contact
Serial Command
Stop
AuxFmt1
Dig0 and Dig1 open circuit
|00DO3!
Green Circle
AuxFmt2
Dig0 open circuit; Dig1 pulled low
|00DO2!
Green Arrow
AuxFmt2
Dig0 pulled low; Dig1 open circuit
|00DO1!
Off
AuxFmt3
Dig0 and Dig1 pulled low
|00DO0!
6.3
Default Print Formats
Table 6-3 shows the default print formats for the
920i
and lists the conditions under which each print format is
used. HDRFMT1 and HDRFMT2 specify header information that can be used by other ticket formats. The
contents of HDRFMT
x
can be inserted by using the <H1> and <H2> formatting commands.
Alert Format Commands
<COMP>
Company name (up to 30 characters)
All
<COAR1>
<COAR2>
<COAR3>
Contact company address, lines 1–3 (up to 30 characters)
<CONM1>
<CONM2>
<CONM3>
Contact names (up to 20 characters)
<COPH1>
<COPH2>
<COPH3>
Contact phone numbers (up to 20 characters)
<COML>
Contact e-mail address (up to 30 characters)
<ERR>
Alert error message (system-generated)
ALERT
See the
iQUBE
2
Installation Manual, PN 106113, for more information about using alerts.
Format
Default Format String
Used When
GFMT
GROSS<G><NL2><TD><NL>
Normal mode, no tare in system
NFMT
GROSS<G><NL>TARE<SP><T><NL>NET<SP2><N>
<NL2><TD><NL>
Normal mode, tare in system
ACCFMT
ACCUM<A><NL><DA><TI><NL>
Accumulator enabled and displayed, or
setpoint print operation with PSHACCM=ON
SPFMT
<SCV><SP><SPM><NL>
Setpoint print operation with PSHPRNT=ON
TRWIN
<NL>ID<SP><TID><NL2>GROSS<TR1>
<NL2><DA><SP><TI><NL>
Press the Weigh In softkey, enter truck ID
number, and press enter.
TRWOUT
<NL6>ID<SP><TID><NL2>GROSS<TR1><NL>TARE<SP>
<TR2><NL>NET<SP2><TR3><NL2><DA><SP><TI><NL>
Press the Weigh Out softkey, enter truck ID
number, and press enter.
TRFMT
REG ID: <TID>: <TR2> SCALE<S> <TD><NL>
Truck register currently displayed
Table 6-3. Default Print Formats
Command
Description
Supported Ticket Formats
Table 6-1. Print Format Commands (Continued)