Rice Lake Adventurer Pro Series Precision, Ohaus - Manual (Page 52)

EN-50 ADVENTURER BALANCES
9.4 Communication
9.4.1 Interface Commands
Commands listed in the following table will be acknowledged by the balance.
The balance will return “ES” for invalid commands.
TABLE 9-6. ADVENTURER INTERFACE COMMAND LIST
Command
Characters
Function
IP Immediate Print of displayed weight (stable or unstable).
P Print displayed weight (stable or unstable).
CP Continuous Print.
SP Print on Stability.
SLP Auto Print stable non-zero displayed weight.
SLZP Auto Print stable non-zero weight and stable zero reading.
xP Interval Print x = Print Interval (1-3600 sec) 0P ends interval Print
0P See above
H Enter Print Header Lines
Z Same as pressing Zero Key
T Same as pressing Tare Key.
xT Establish a preset Tare value in displayed unit. X = preset tare value. Sending 0T clears tare (if
allowed).
PT Prints Tare weight stored in memory.
ON Brings out of Standby
OFF Goes to Standby.
C Begin Span Calibration
IC Begin internal Calibration, same as trigger from calibration menu.
AC Abort Calibration. Attention: when LFT ON, the operation is not allowed.
PSN Print Serial Number.
PV Print terminal software version, base software version and LFT ON (if LFT is set ON).
x# Set Counting APW (x) in grams. (must have APW stored)
P# Print Counting application APW.
x% Set Percent application reference weight (x) in grams. (must have reference weight stored)
P% Print Percent application reference weight.
xS 0 = print unstable data, same as IP; 1 = print stable only
1)
, same as SP.
xRL 0 = disable response; 1 = enable response. This command only controls the “OK!” response.