Rice Lake AX 3040 - Manual (Page 10)

6 AX3040 Operator Manual
2.4.3 Installing Access Ramps
Access ramps are designed to fit securely to the Rice Lake AX3040.
Figure 2-6. Access Ramp
Once the Rice Lake AX3040 is set in place, ramps can be fitted to the weigh pad using release pins.
1. Set ramps in place, tightly against the load cell end mount of the weigh pad. with the ramp tabs on each
side of the load cell mount end of the weigh pad. See Figure 2-7.
2. The holes on the ramp tabs and on the load cell mount end of the weigh pad must match up. Install the
release pin ensuring it goes through both the ramp and the load cell mount.
Release Pin – holds the
weigh pad and ramps
together.
Figure 2-7. Release Pin Location