Rice Lake Counterpart Configurable Counting Indicator - User Manual - Version 2.0 - Manual (Page 64)

56 Counterpart User Manual
5. Set the default gateway, DNS Pri, DNS Sec - no changes.
6. Set the local port - 10001.
7. Set the remote IP address - 192.168.0.02 (this is set same as computer above).
8. Set the remote port - 5466.
9. Set the Vault - set onboard.
10. Set up softkey - Code.
5.6.2 Using Weighvault
Once the above criteria have been met, IDs can then be entered into WeighVault and saved on the PC’s hard
drive. The Edit Product dialog box in Figure 5-3 shows ID parameters which can be saved in WeighVault.
For testing purposes, enter a few part numbers and click on Save Changes to Database .
Figure 5-3. WeighVault Edit Product Dialog Box
To access a saved ID from WeighVault over the network connection,
1. Using the Counterpart front panel, press the CODE key.
2. Enter an ID CODE value.
3. Press the TARE(Enter) key. The ID CODE is loaded and ready to use.
If the demo feature is complete and not being used permanently with WeighVault, go the your network
settings and turn off the Assign IP Address feature.
Note