Rice Lake Counterpart Configurable Counting Indicator - User Manual - Version 2.0 - Manual (Page 76)

70 Counterpart User Manual
Command Description
Supported Ticket
Formats
<G> Gross weight in displayed units GFMT, NFMT, TOTALFMT,
PALFMT, CFMT, ACCFMT
HDRFMT1, HDRFMT2
<N> Net weight in displayed units
<T> Tare weight in displayed units. Add four before bracket to print header
<A> Accumulated weight in displayed units
<AC> Number of accumulator events (5-digit counter)
<AD> Date of last accumulator event
<AT> Time of last accumulator event
<UID> Unit ID number
<CN> Consecutive number
<C> Piece count, current scale
<C#n> Piece count, scale n
<NLnn> New line (nn = number of termination (<CR/LF> or <CR>) characters)*
<SPnn> Space (nn = number of spaces)*
<SU> Suppress Units. Toggle weight data format (formatted/unformatted)**
<TI> Time
<DA> Date
<TD> Time & Date
<H1> Header 1
<H2> Header 2
<IDC> Loaded ID Code - 32 characters maximum
<IDD> Loaded ID Description - 32 characters maximum
<IDLC> Loaded ID Location - 12 characters maximum
<IDP> Loaded ID Part Number - 32 characters maximum
<IDLT> Loaded ID Lot - 32 characters maximum
<IDU> Loaded ID Units - 1 character maximum
<IDT> Loaded ID Tare - 9 characters maximum (range 0.0 to 9999999.0)
<IDW> Loaded ID Unit Weight - 9 characters maximum (range 0.0 to 9999999.0)
<IDQ> Loaded ID Quantity - 11 characters maximum (range -2000000000 to 2000000000)
<C> Piece Count, current scale - 7 characters maximum (no explicit maximum value)
<C#n> Piece Count, Scale n
<TTLV> Totalization Value - 11 character maximum (range -2000000000 to 2000000000). When not in
totalization mode, the value will be 0.
<TTLC> Totalization Count - 4 characters maximum. When no in totalization mode, the value will be 0.
<TT> Transaction Type - gives a “1” for receiving (in) or “0” for (sending out)
Note: This command cannot be used in any other format except Weighvault
<TTLW> Print totalized weight. When not in totalization mode, the value will be 0.
<SCV> Setpoint captured weight value SPFMT
<SN> Setpoint weight number
<STV> Setpoint target weightvalue
<SPV> Setpoint preact weight value
<SPM> Setpoint weight mode
<SCVC> Setpoint captured count value
<STVC> Setpoint target count value
<SPVC> Setpoing preact count value
Table 7-1. Print Format Commands