Rice Lake Counterpart Configurable Counting Indicator - User Manual - Version 2.0 - Manual (Page 74)

68 Counterpart User Manual
6.1.6 Normal Mode Commands
The normal mode print commands (see Table 6-10) transmit data to the serial port on demand in either setup or
normal mode.
6.1.7 Unique Commands
6.1.8 Setpoint Tokens
Command Description Values
CONSNUM#n Set consecutive number 0–9 999 999
UID#n Set unit ID nnnnnnn
SD#n Set date MMDDYY, DDMMYY, YYMMDD, or YYDDMM. Enter six-digit
date using the year-month-day order specified for the DATEFMT
parameter, using only the last two digits of the year.
ST#n Set time hhmm (enter using 24-hour format)
SX#n Start serial port streaming OK or ??
An EX command sent while in menu mode does not take effect
until the indicator is returned to normal mode.
The EDP.Stream must be set to LFT or INDUST for this
command to work.
EX#n Stop serial port streaming
XG#n Transmit gross weight in displayed units nnnnnn UU
where nnnnnn is the weight value, UU is the units.
NOTE: You can also send XGP, XGS, XGT, XTP, etc. to specify
primary, secondary or tertiary (P.S.T.).
XN#n Transmit net weight in displayed units
XT#n Transmit tare weight in displayed units
XA#n Transmit accumulator value
RS Reset system Soft reset. Used to reset the indicator without resetting the
configuration to the factory defaults.
SK#n Command to perform function assigned to softkey Softkey digital I/O softkeys functions.
Table 6-10. Normal Mode Serial Commands
Command Description
DUMPID.INDEX=n To dump an ID by register
DUMPID.CODE=n To dump an ID by code
KDISPMODE Set or request the current display mode. KDISP=COUNT. Will switch to that mode. This only temporariliy
switches display. Default is set by dispmode parameter.
Other choices include:
COUNT
WEIGHT
UNIT WEIGHT
ETH.ECHO Only applies when Vault is set to off.
Table 6-11. Unique Commands
Command Description Values
<SCV> Setpoint captured value 9 characters maximum
<SN> Setpoint number 1 character maximum
<STV> Setpoint target value 9 characters maximum
<SPV> Setpoint preact value 9 characters maximum
<SPM> Setpoint weight mode “gross” or “net”
<SCVC> Setpoint captured count value 9 characters maximum
<STVC> Setpoint target count value
<SPVC> Setpoing preact count value
Table 6-12. Setpoint Token Commands