Rice Lake Datalogic PowerScan RF 8000 Series Laser Scanner - Manual (Page 181)

MESSAGE FORMATTING
173
• The cursor row position is not affected by the currently selected font. The
display always has 4 rows, so when writing with the large font, actually two rows
are written to: the current one and the one below it. You will need two ESC E
commands to step from one row to the next when using the large font.
• The cursor column position is affected by the currently selected font. Therefore,
column 6 is 36 pixels from the left border only if you last selected the 6x8 font;
otherwise it could be 48 or 72 pixels from the left border.
6.1.2 Font Selection
ESC [ 0 m Normal mode
ESC [ 7 m Reverse mode
ESC # 4 Large font: subsequent characters are written on the current row and
the row below it using the 12x16 font which allows for two rows of
eight characters on the display.
ESC # 5
Normal font: subsequent characters are written using the 6x8 font,
which allows for four rows of sixteen characters on the display.
ESC # 7 Medium font: subsequent characters are written using the 8x8 font,
which allows for four rows of twelve characters on the display.
6.1.3 Clearing Display
ESC [ 0 K From cursor position to end of line inclusive
ESC [ 1 K From beginning of line to cursor position (not inclusive)
ESC [ 2 K Entire line
ESC [ 0 J From cursor position to end of display inclusive
ESC [ 1 J From beginning of display to cursor position (not inclusive)
ESC [ 2 J Entire display; moves cursor to upper left corner on display
6.1.4 LED and Beeper Control
ESC [ 0 q Emit short High tone + short delay
ESC [ 1 q Emit short Low tone + short delay
ESC [ 2 q Emit long Low tone + short delay
ESC [ 3 q Emit good read tone
ESC [ 4 q Emit bad tx tone
ESC [ 5 q Wait 100 ms
ESC [ 6 q Turn on the green LED
ESC [ 7 q Turn off the green LED
ESC [ 8 q Turn on the red LED
ESC [ 9 q Turn off the red LED