Rice Lake Stationary Livestock Scale - MAS-LC - Operators Manual - Manual (Page 11)

Assembly and Installation 7
6. Align top hinge section on gate with lower hinge section on upright and lower gate onto the bottom hinge
section.
Latch must align
with the strike
plate when gate is
installed.
Install washers as
required to ensure
latch/striker plate
alignment.
Top hinge section
Bottom hinge
section
Important
The latch should line up with the strike plate welded to the end upright. If it doesn’t line up, washers (PN
151209) are supplied to adjust the gate. Remove gate from hinges and place washers on the upright
hinge, then reinstall the gate. Use washers as needed to align the latch to the striker plate.
Figure 2-5. Gate Installation and Alignment