Rice Lake Sartorius Midrics 1 and 2 Series - Installation Instructions - Manual (Page 19)

19
Data Interfaces
GMP-compliant Printouts
When the corresponding menu item is
active, the measured result is bracketed
on the printout by a GMP header and
a GMP footer (GMP: “Good Manufac-
turing Practice").
The GMP header precedes the first
measured result. The GMP footer is
printed either after each measured
result (“ISO/GLP/GMP: For 1 application
result," menu item 7.11.2), or after the
last result in a series of measurements
(“ISO/GMP/GLP: For several application
results," menu item 7.11.3). To end a
series of measured results, press and
hold the p key (> 2 sec).
In this case, the A symbol is displayed
after the GMP header is printed and
remains in the display until the GMP
footer is printed.
At the end of a calibration procedure,
the GMP printout is generated auto-
matically.
If you use a label printer for GMP-com-
pliant printouts and menu item 7.11.3
is active, the header and footer are
printed on two different labels.
To generate GMP-compliant printouts
on labels, select menu item 7.11.2.
Examples of GMP headers and one example of a GMP footer are shown in the following:
------------------- Dotted line
14.01.2007 09:43 Date and time 1)
Typ MIS2 Midrics model
Ser.no. 12345678 Midrics serial no.
Vers. 1.1007.12.1 Software release for application
BVers. 01-25-01 Software release for basic version
------------------- Dotted line
GMP footer:
------------------- Dotted line
14.01.2007 09:45 Date and time 1)
Name: Field for operator signature
Blank line
------------------- Dotted line
1) YDO01M-232 (Option A31) required