3 scale relocation, See figure 2-8 – Rice Lake SURVIVOR ATV User Manual
Page 10
Bolt-on Wing
6
ATV Portable Truck Scale Assembly Instructions
Figure 2-8. Bolt-on Wing
12. Back fill material against bulkheads to establish a ramp and approach as needed.
13. Calibrate the scale (see Section 4.0 on page 10).
2.3
Scale Relocation
Use the following steps when relocating the ATV portable truck scale series truck scale.
1. Remove load cell cover plates.
Chain
Pin
Load
Cell
Wiring
Figure 2-9. Load Cell Cover Plate Removed
2. Remove hitch pin that holds stand in retracted position (see Figure 2-9).
3. Jack up each corner of module until hitch pin can be re-installed in shipping position.
4. Install bolt connecting stand to bulkhead base (see Figure 2 on page 5).
5. Install shipping bolts on end of modules (see Figure 2-5 on page 5).
6. Remove home run cable and expansion cable.
7. Remove spacer tubes.
8. Remove backfill material.
9. Relocate modules starting with bridge module.