Rice Lake Zebra GK420t - Manual (Page 3)

iii
12/14/07 GK420t User Guide 980610-001 Rev. A
FCC Compliance Statement
This device complies with Part 15 rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for Class B Digital
Devices, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a residential
environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the product manuals, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, the user is encouraged to do one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced RF service technician for help.
The user is cautioned that any changes or modifications not expressly approved by Zebra
Technologies could void the user’s authority to operate the equipment. To ensure compliance,
this printer must be used with fully shielded communication cables.
G Series Printers
•
Vi ewi ng the laser output wi th certain optical i nstruments (f or exampl e, eye loops, magnifi ers and mi croscopes) within
a distance of 100mm m ay pose an eye hazard.
•
Use of control s or adjustments or perf ormance of procedures other than those specif ied herei n may resul t i n hazardous
radi ati on exposure.
•
Do not tam per or attempt to repai r any sensor i nside this product. No servi ceabl e sensors insi de.
•
Do not stare into Gap (Web) or Dispenser (Peel) sensors. Avoid possibl e exposure to hazardous laser radi ati ons.
Caution • CLASS 1M LASER PRODUCT