Ring Communications DNA200 - Manual (Page 10)

DNA200 OPERATIONS MANUAL 10 2008/05/01
CONFIGURATION
Note! Not used with American Dynamics Alarm input.
One DNA100 and a PC is used for programming the DNA200. The DNA100 sets up a link between
the PC and the DNA200. The Configuration is done from the PC and the information is stored in battery
RAM in the DNA200. When the system is first installed the Battery RAM must be reset before the system
is configured (see page 8).
SYNTAX
TYPE FONTS
boldface type
cr
indicates user input
Courier font indicates output
COMMAND
The command consists of a command word plus one or more parameters.
The command may be entered on one line with the parameters separated by spaces.
>command par1 par2 par3
cr
The command may be entered in prompt mode with parameters separated by carriage return. The prompt
will indicate what type of parameter value is required.
>command
cr
Prompt>par1
cr
Prompt>par2
cr
Prompt>par3
cr
>
PROMPT
< > Angle brackets enclose input parameters.
$ Hexadecimal value (default is decimal).
- Range of values may be entered.
.. Periods indicate that only ONE value is required from the range of values.
* Wild card means all values in a range of values.
/ Optional input selection separator.