Ring Communications DXC910 - Manual (Page 10)

10 DXC910 OPERATIONS MANUAL 2007/05/17
GROUP CALL
Allows for one way paging from one station to a group of stations and will override normal calls (they will
reconnect when the Group Call is completed). The initiating station must have privilege “Group Call Access”.
The duration of the Group Call is limited to 60 seconds (programmable subscriber timer). There are 7 Group
Calls in the system with access call numbers 71-77. The Group Call is terminated with X, or 8 for call back
(meet me). One of the stations can then dial 90 to be connected to the Group Call initiator. The call back is
active until one station dials 90 or a new call back is activated from another All Call or Group Call. Call number
of the receivers are entered in the Group Call groups (group 1-7). All station may be a members of multiple
Group Call groups. Only one Group Call can be active at a time. Stations calling Group Call when it is in use
may camp on until it is free.
PROGRAM DISTRIBUTION
The system has one program channel for distribution of music or other programs source.
The access code is 98. The connection to program distribution does not effect normal intercom operations.
When a call is initiated or received, the music is put on hold until the call is completed and then it is auto-
matically reconnected. The feature is enabled with dip-switch U48 no.3 and 4 on NFE1643.
TWO WAY RADIO
The RM5000 system may be connected to a radio base station for communication on a closed two-
way radio network. An interface unit is required and is given an ordinary subscriber number. If the radio
system is simplex PTT then the subscriber number should be programmed with privilege “Simplex Always”
The radio receive signal may be connected to the program distribution channel for monitoring.
TELEPHONE NETWORK
An interface can be supplied to operate between the public telephone network and the RM5000. The
interface is used to make calls from any intercom station to the telephone network and to make call from an
outside telephone to any intercom station.
The interface may be used as a speed dialer to a telephone number used for answering intercom calls from
elevator intercoms in a night transfer mode of operation. The device type of the interface is set to PTT, and
the speed dial number is programmed from a telephone calling the interface (or from a AA916 plugget into
the port instead of the telephone interface). The feature code for programming is 95 and the speed dial
telephone number is then dialed in from the telephone (maximum 16 digits). Dip switch no. 2 on U48 must
be on during this programming. A delay may be entered as *1 for one second delay to *9 for 9 second
delay. Example: 95*29*31234567 will delay 2 seconds (waiting for dial tone), dial 9, delay 3 seconds, then
dial 1234567. When a call enters the personal que of the interface it will speed dial the remote telephone
number, connect the station in que to the telephone line and then wait for disconnect from the remote