Sage Nutri Juicer Pro BJE820UK - Manual (Page 18)

17
oPEratIng yoUr nEW aPPlIanCE
1. Wash your selection of fruit and/or
vegetables ready for juicing. Prepare
fruits according to charts above.
2. Based on the type of fruit or
vegetable you are juicing/pureeing
select either the juice extractor or the
puree extractor.
WARNING
Do not put hard fruit and vegetables
(ie. Carrots, apples, fresh beetroot,
etc.) or ice through juicer when using
puree extractor. This could damage
parts of the unit.
3. Ensure the dual disc juice processor
is correctly assembled – see
previous instructions. Ensure the
juice extractor or puree extractor
is thoroughly cleaned before each
use (refer to cleaning on pages
19). Ensure you place the juice
jug (or glass) under spout before
commencing juicing.
4. Plug the power cord into a 230V
power outlet and then turn the
power on at the outlet. The light
surrounding the START/STOP
button will illuminate.
notE
The light will be illuminated for
2 minutes before fading into sleep
mode. The light will come back on by
activating any of the controls.
5. Use the speed selector table as
a guide for juicing different fruit
and vegetables. Push the START/
STOP button and the unit will
automatically start.
6. With the motor running, place food
into the Feed chute using the food
pusher, gently guide food down
the feed chute. Do not exert excess
pressure. To extract the maximum
amount of juice, always push the
food pusher down slowly.
USIng tHE JUICE ExtraCtor
As fruits and vegetables are processed juice
will flow into the juice jug and the separated
pulp will accumulate in the pulp container.
The pulp container can be emptied during
juicing by turning juicer off at the control
panel and then carefully removing the pulp
container. Replace the empty pulp container
into position before continuing to juice.
notE
Do not allow the pulp container
to over fill as this may affect the
operation of appliance.