Smart Power Systems HR-110 User Manual
Page 18
Smart Power
®
Systems
A. C. MODULAR GENERATOR SYSTEM
Page 17 of 53
Installation Guide
1.
Mount the pump securely to the Power Take-Off (PTO). This may require attaching
a mounting bracket to the PTO housing prior to mounting the pump.
WARNING:
Always mount the hydraulic pump in a position with the pump controls up.
Mounting the pump in any other orientation will not allow hydraulic fluid in the
pump to reach the correct level before starting, causing premature wear of the
pump, thus voiding the system’s warranty. The pump and undercarriage
components will corrode if they are left unprotected. It is advisable to paint them
before completing the installation.
2.
Locate and bore mounting holes for generator tray assembly as shown in Figure 7.
Maintain minimum clearances as indicated in Figure 3, Figure 4 and Figure 5.
Hole pattern for mounting HR-6.2, HR-8, HR-10 and HR-110 tray assemblies
Figure 7