Smart Power Systems HR-110 - Manual (Page 52)

Smart Power
®
Systems
A. C. MODULAR GENERATOR SYSTEM
Page 51 of 53
3.
Disable the generator Pump Set option.
After the pump has been properly adjusted, disable the Pump Set option by performing
the following steps:
Step a: Hold Mode until
Amps Line 1 Blinks
.
Release switch so 
appears.
Step b: Press mode twice
to make  appear.
Step c: After selecting
, Press On/Off until
 appears.
Disabling pump set option
Figure 31
a. Press and hold the Mode switch until the Amps Line 1 field blinks with  (more
than 10 seconds). Release the switch while the Amps Line 1 field is blinking to
make
 appear. Reference Figure 31.
b. Press the Mode switch until
 appears.
c. Press the On/Off switch until an
 appears, indicating Pump Set option is
inactive.
d. Put system into Normal mode by pressing the Mode switch.