Smart Power Systems HR-110 - Manual (Page 28)

Smart Power
®
Systems
A. C. MODULAR GENERATOR SYSTEM
Page 27 of 53
WARNING:
The SPS Model HR-6.2, HR-8, HR-10 and HR-110 have been pre-set at the factory to
provide correct frequency and voltage. No pump adjustment is required. If it
appears the pump needs to be adjusted, contact Smart Power
®
Systems at (231)
832-5525 before proceeding. Damage to generator from improper pump adjustment
will void the system’s warranty.
Improper ventilation will result in system overheating, reduced performance and
possible damage to the system and/or cause personal injury. If the system is
installed such that improper ventilation exists, the system’s warranty will be voided.
12.
Set “auto-start” option.
If the auto-start option is enabled, the generator will begin generating electricity
whenever the PTO is engaged. If the auto-start option is disabled, the generator
will not output electricity after PTO engagement until the “on/off” switch is pressed.
Select the auto-start function by performing the following steps:
Step b: Hold Mode until
Amps Line 1 Blinks
.
Release switch so 
and  appear.
Step c: Press On/Off
until the desired value
appears
Figure 15