Smart Power Systems HR-30 - Manual (Page 25)

Smart Power
®
Systems
A. C. MODULAR GENERATOR SYSTEM
Page 24 of 50
Enabling System Purge Option
The purge option can also be set by performing the following steps:
Step 3: Hold Mode
until Amps Line 1
Blinks
88. Release
switch so 0Pt
appears.
Step 4: Press mode to
make
Pvrg appear.
Step 5: Press On/Off
until y appears.
Figure 13
1. If the Command & Control Center is dark, press the Mode switch to put
the display into Normal mode.
2. If the Display looks like Figure 13, The purge option is enabled.
3. Otherwise, press and hold the Mode switch until the Amps Line 1 field
begins blinking
88 (more than 10 seconds). Release the switch so 0Pt
appears. Reference Figure 13.
4. Press (and release) the Mode switch until
PvrG appears.
5. Press the On/Off switch until a y appears, indicating Purge option is
Active.
6. Return to system purge display by pressing the Mode switch repeatedly
until the screen shown in Figure 13 is displayed. Purge will still be active.
Indicates whether the
generator is
0n or 0ff
Example of display with purge option set
Figure 14
f. Engage the Power Take-Off (PTO). (Note: Pump may sound rough for a few
minutes due to entrapped air.) Make sure the Command & Control Center