ThingMagic M6e - Manual (Page 30)

Power Requirements
A D I V I S I O N O F T R I M B L E
30 Hardware Overview
Minimum cable insertion loss = 0.8 dB
Pmax = 36 - 6 + 0.8 = 30.8 dBm
The maximum RF power that may be set using this configuration is 30.8 dBm (see
Warning above).
Power Supply Ripple
The following are the minimum requirements to avoid module damage and to insure
performance and regulatory specifications are met. Certain local regulatory specifications
may require tighter specifications.

5 Volt +/- 5%,

Less than 25 mV pk-pk ripple all frequencies,
 Less than 11 mV pk-pk ripple for frequencies less than 100 kHz,
 No spectral spike greater than 5 mV pk-pk in any 1 kHz band.
C A U T I O N ! ! !
Operation in the EU Region (under ETSI regulatory specs) may need
tighter ripple specifications to meet ETSI mask requirements.
Power Consumption
The following table defines the power/transmit mode settings and power consumption
specifications for the M6e. Additional details about Power/Transmit Modes can be found