Fault_general_tag_error – 40ah, Cause, Solution – ThingMagic M6e User Manual
Page 77: Fault_data_too_large – 40bh, Fault_protocol_invalid_kill_password – 40ch, Fault_protocol_kill_failed - 40eh, Fault_general_tag_error – 40ah 77, Fault_data_too_large – 40bh 77, Fault_protocol_invalid_kill_password – 40ch 77, Fault_protocol_kill_failed - 40eh 77
Protocol Faults
Appendix A: Error Messages
77
FAULT_GENERAL_TAG_ERROR – 40Ah
Cause
This error is used by the GEN2 module. This fault can occur if the read, write, lock, or kill
command fails. This error can be internal or functional.
Solution
Make a note of the operations you were performing and contact ThingMag
FAULT_DATA_TOO_LARGE – 40Bh
Cause
A command was received to Read Tag Data with a data value larger than expected or it is
not the correct size.
Solution
Check the size of the data value in the message sent to the reader.
FAULT_PROTOCOL_INVALID_KILL_PASSWORD – 40Ch
Cause
An incorrect kill password was received as part of the Kill command.
Solution
Check the password.
FAULT_PROTOCOL_KILL_FAILED - 40Eh
Cause
Attempt to kill a tag failed for an unknown reason
Solution
Check tag is in RF field and the kill password.