ThingMagic M6e - Manual (Page 90)

Devkit Hardware
90 Appendix B: Getting Started - Devkit
c. Select View | Devices by Type | Ports (COM & LPT) The device appears as
Mercury6eUltra (COM#).
Devkit Jumpers
J8
Jumpers to connect M6e I/O lines to devkit.
J9
Header for alternate power supply. Make sure DC plug (J1) is not connected if using J9.
J10, J11, J13, J15
Jump pins OUT to GPIO# to connect M6e GPIO lines to output LEDs. Jumpe pins IN to
GPIO#
to connect M6e GPIO to corresponding input switches SW[3-6]GPIO#. Make
sure GPIO lines are correspondingly configured as input or outputs (see Configuring GPIO
Settings ).
J14
Can be used to connect GPIO lines to external circuits. If used jumpers should be
removed from
J10, J11, J13, J15 .
J16
Jump pins 1 and 2 or 2 and 3 to reset devkit power supply. Same as using switch SW1
except allows for control by external circuit.
J17
Jump pins 1 and 2 to use the 5V INPUT and GND inputs to provide power. Jump pins 2
and 3 to use the DevKitʼs DC power jack and power brick power.
J19
Jump SHUTDOWN to GND to enable module. While grounded SHUTDOWN pushbutton
(SW2) will break circuit and shutdown the M6e (see
M6e Digital Connector Signal
Definition ). AUTO_BOOT controls Reset Line .