Torbal AG Series - Manual (Page 11)

- 11 -
6. Using the scanner with the SQC Process Control function:
1.
To use the scanner with the SQC Process Control function you must first enable SQC Process Control
mode and make sure that limit set labeling is turned on.
2.
Start SQC Process Control and press the FUNCTION key to enter into the database.
3.
Select an empty slot and pres the RIGHT ARROW key
4.
Highlight name and press ENTER.
5.
Instead of typing in the name, scan the barcode associated with that sample.
6.
Configure your limit set, highlight EXIT/SAVE and press ENTER.
7.
Place a container on the pan and press the TARE key.
8.
At this point you can continue using the SQC Process Control function.