Welch Allyn Connex CS Central Station & Server - User Manual - Manual (Page 89)

Connex CS Admin Guide Localize Station settings 83
5. There are 3 different areas within auto discharge functions that can be managed, and
are described in sections below.
6. Refer to the Welch Allyn Connex CS Directions for Use, section titled “Automatic
discharge” for general clinical information about this feature.
7. Make changes as needed.
8. Click Save when changes are complete.
ADT auto discharge settings
1. Settings starting with “ADTAUTODISCHARGE” controls automatic discharge
behavior for patients which have received an ADT message.
Figure 12-13: ADT patients auto discharge related settings
2. The following table describes the function of each setting.
Table 12-1: ADTAUTODISCHARGE setting functions and default values
Setting Label Function Default value
ENABLED Turns Auto Discharge functions on/off for patients
which have received an ADT message. TRUE (on)
EXECUTIONFREQUENCY.MINUTES Controls how often the process runs, in MINUTES 60
EXECUTIONSEQUENCE Controls the run order between Late ADT Matching,
Confirmed Auto Discharger, and ADT Auto Discharger
processes. 3 (third)
ACTIVITY.STALEPERIOD.MINUTES Determines a period of time in MINUTES for which no
activity has taken place for the patient including ADT
messages, monitoring, test taken, edits to
demographics or visit data. 10080 (7 days)
Caution Do not change settings for EXECUTION SEQUENCE unless directed
by Welch Allyn Engineering.