Welch Allyn CardioPerfect Workstation SpiroPerfect Module - User Manual - Manual (Page 31)

CardioPerfect Workstation
SpiroPerfect Module
– User Manual
DIR 80012334 Ver. F 31 / 95
Figure 6.1 The Ambient settings dialog box
1. Enter the Temperature value. (The value for the ambient temperature.)
2. Enter the Humidity value. (The value for the ambient air humidity.)
3. Enter the Pressure value. (The value for the ambient barometric pressure.)
Tip:
In the spirometry settings, the ambient units for temperature and pressure can be changed.
Tip:
There is an additional option available to update the Ambient settings:
1. Select Calibrate located on the Toolbar (or press F10)
2. Enter the ambient setting information in the Pre-Calibration dialog box. Updating
ambient settings is recommended when a calibration is going to be performed.