Compaq Deskpro 2000 Series - Manual (Page 112)

6-12 Upgrading the Minitower Computer
Writer: Holly Jahangiri Saved by: ACastle Saved date: 07/25/97 2:13 PM
Pages: 28 Words: 3072 Template: c:\msoffice\templates\comm.dot
File Name Ch6.doc Part Number 278019-001
✎ The handle on the ZIF socket in your computer may not look
identical to the handle shown in the drawing. All handle types
perform the same function.
6. Align the new processor so that the single pin on the inside
corner of the processor aligns with the single pinhole on the
inside corner of the socket.
7. Install the processor by lowering it into the ZIF socket.
8. Push the handle on the ZIF socket back into place to secure
the processor.
9. If the processor has a raised center, install thermal pad
3
number 243226-001 on top of the processor before
installing the heatsink.
If the processor has a flat center, install thermal pad
3
number 184616-002 on top of the processor before
installing the heatsink.
CAUTION: Using the wrong thermal pad may cause the processor
to overheat or short, resulting in failure.
10. Install the heatsink and the heatsink retaining clip.
11. Set SW2 DIP switches to establish the processor speed
appropriately. Refer to Appendix E, “System Board
Jumpers and Switches,” or to the label inside the computer
for detailed setting information.