Compaq Deskpro 2000 Series - Manual (Page 97)

5-26 Upgrading the Desktop Computer
Writer: Holly Jahangiri Saved by: Holly Jahangiri Saved date: 07/16/97 2:46 PM
Pages: 28 Words: 3162 Template: c:\msoffice\templates\comm.dot
File Name Ch5.doc Part Number 278019-002
6. Connect the drive power cable 1 and the signal cable 2.
Connecting Cables to the Hard Drive
7. Remove the bezel blank from the front bezel if necessary.
To do this, lay the front bezel face down on a protected
work surface. Push the tab that is on the right of the bezel
blank to the left, then rotate the bezel blank up and out of
the front bezel.
Removing the Bezel Blank
8. Run Computer Setup to configure the new drive, if
necessary. Refer to Chapter 3, “Using Compaq Software,”
for instructions.