Canon FAX-TT250 - Manual (Page 31)

31
5
SENDING D
O
CUMENTS
Redialling when the line is busy
Manual redialling
Press [Redial/Pause] to dial the last number you dialled with the numeric buttons. (This starts redialling regardless of
whether automatic redialling is enabled.)
■ Cancelling manual redialling
To cancel manual redialling, press [Stop]. The fax will feed out the document. See Removing a jammed document
from the machine, p. 45.
Automatic redialling
■ What is automatic redialling?
When you are sending a document and the receiving party’s line is busy, the fax waits the specified time and then
dials the same number again. You can set the fax to redial several times if previous attempts fail because of a busy
signal.
■ Cancelling automatic redialling
■ Setting the options for automatic redialling
You can set the following options for automatic redialling:
• Whether or not the fax redials automatically.
• The number of times the fax attempts to redial.
• The time interval between redialling attempts.
1 Press [Stop].
If you want to cancel a memory-sending transmission while the fax is waiting to redial, you will have to delete the
document from memory (see p. 35).
1 Press [Function], then press [Start/Copy].
2 Use [ ] or [ ] to select <TX SETTINGS>, then press [Start/Copy].
3 Use [ ] or [ ] to select <AUTO REDIAL>, then press [Start/Copy].
• To disable automatic redialling, use [ ] or [ ] to select <OFF>, then press [Start/
Copy]. Press [Stop] to return to standby mode.
• To enable automatic redialling, use [ ] or [ ] to select <ON> and continue with the
steps below.
4 Press [Start/Copy] twice.
ON
2TIMES
Thalia.book Page 31 Tuesday, September 28, 2004 10:13 AM