B&C Technologies DI-225 Industrial - Manual (Page 23)

H . PREPARATION FOR OPERATION/START-UP
The following items should be checked before attempting to operate the dryer:
1. Read and follow All “caution”,“warning”and“direction” labels attached to the dryer.
2. Check incoming supply voltage to be sure that it is the same as indicated on the dryer data
label affixed behind the right control box door. In the case of 208 VAC or 230/240 VAC, the
supply voltage must match the electric service exactly.
3. Check to be sure drive belts between idler pulley and motor pulley have been re-connected.
NOTE: The drive belts were disconnected at factory prior to shipment.
4. Be sure All side and base panels and the belt guard are on the dryer.
5. Check All service doors to assure that they are closed and secured in place.
6. Be sure the lint drawer is securely in place.
NOTE: Lint drawer must be all the way in place to activate safety switch
otherwise the dryer will not start.
10. Rotate the basket (tumbler/drum) by hand to be sure it moves freely.
11. Check bolts, nuts, screws, terminals, and fittings for security.
12. Check to insure air supply (80 psi) is connected to dryer.
13. STEAM - check to insure All steam shut-off valves are open.