Sangean DDR-62 (R1) - Manual (Page 19)

8
GB
WPA and WPA2 are similar, although WPA2 offers a higher level of security. Whichever
you selected in step 7, you then have to specify the variant used. They are TKIP (Temporal
Key Integrity Protocol) and AES (Advanced Encryption Standard). As previously, the setting
should match that used by your router. Some routers allow both to be specified, and the
router will use whichever variant is supported by the connected device. AES is regarded as
the more secure option if it is available.
The radio will then require you to enter the encryption key. This must be a string of between 8
and 6 characters and must be identical to the key which has been entered into your router.
Note – the encryption key is sensitive to the use of upper and lower case letters and
symbols. Take care to enter the key exactly, or the radio will not be able to connect to your
router. The three controls on the right-hand side of the screen have special functions. You
can quickly access these by pressing the Info button and then use the Folder Up or Down
and Select buttons as needed:
select ‘ ’ to erase a character just entered (long press to clear); Info again to continue
select ‘ ’ when the complete encryption key has been entered
select ‘ ’ to cancel and go back to the TKIP / AES options screen
Once the key is entered the radio should connect to the network.
While the radio is trying to connect to the network, it will display ‘Processing…’ when
checking the encryption key (if using the WiFi connection) and then ‘Connecting…’. If the
connection is made successfully, the radio will return to the Network settings menu. If the
unit cannot connect, then it will display a ‘Failed to connect’ message and will return to the
SSID entry screen (step 6).Once connected, the network settings are stored in the radio. The
settings are retained whenthe radio is disconnected from the mains. You may now use the
Back and Radio or Media buttons to access the functions of your radio.
9.
0.
.
The three controls on the right-hand side of the screen have special functions. You can
quickly access these by pressing the Info button and then use the MenuUp or Down and
Select buttons as needed:
select ‘ ’ to erase a character just entered (long press to clear); Info again to continue
select ‘ ’ when the complete encryption key has been entered
select ‘ ’ to cancel and go back to the SSID settings screen
Once the key is entered the radio should connect to your network. Please skip to step .