Sangean DDR-62 (R1) - Manual (Page 94)

9
Auxiliary input socket
A .5mm Auxiliary Input socket located on the rear of your radio is provided for connecting the
audio signal from an external audio source such as an MP or CD player.
. Connect a stereo lead from the headphone output of your MP or CD player to the Aux In socket
located at the rear of the radio. Typically this lead will have a .5mm stereo plug at both ends.
2. Switch on your radio.
. Press the Radio button until 'AUX in' mode is shown on the display.
. Press the 'play' on the connected audio device. If you are using its headphone output for the
connection, set its volume control to a level of somewhere between two-thirds and maximum
(the objective is to get a strong audio signal but without too much distortion). Then adjust the
volume on the radio as required.
Note:
if using an iPod as the sound source, you may need to set its output to maximum to get an
adequate audio signal level.
5. After use, disconnect your player in order to listen to your radio conventionally.