Sangean DDR-62 (R1) - Manual (Page 54)

5
FM Radio
Operating your radio in FM mode
Carefully extend the telescopic aerial and press the Standby button to switch on your radio.
Press the Radio button as needed to select FM radio mode.
Press the Tuning Up button (on the radio) or the Tunning Up button (on the remote control) and
then the Auto button on the remote control. The displayed frequency will increase. Your radio
will scan up the FM band from the currently displayed frequency and will stop scanning when it
finds a station of sufficient strength.
The display will show the frequency of the signal which has been found. If RDS information
is available, after a few seconds the display will show the radio station name. If you only hear
hiss or interference, simply press the Auto button to scan further. Your radio may have found a
spurious interference signal.
To find more FM stations press the Auto button (on the remote control) to repeat the scan
operation. To scan down in frequency, press the Tunning Down button (on the radio) or the
Tunning Down button (on the remote control) and then the Auto button. Your radio will scan
down the FM band from the currently displayed frequency and will stop scanning when it finds
a signal of sufficient strength.
Alternatively press and hold the Tunning Up on the radio to scan up in frequency or the
Tunning Down button to scan down the FM band.
When the end of the waveband is reached your radio will recommence tuning from the
opposite end of the waveband. Use the Volume buttons to adjust the sound level as needed.
.
2.
.
.
5.
6.
7.