Sangean DDR-62 (R1) - Manual (Page 79)

78
GB
Clock and Alarms
Automatically updating the clock
Your radio will normally update the clock automatically when connected to the internet. If you
enter a time setting manually, the radio will calculate a local time offset which is then stored in
memory. Whenever it synchronizes the clock using the internet, including after a power failure,
your radio will then set the clock automatically using this information. You may wish to use the
radio away from the internet, in which case you may specify that the unit sets its clock from
DAB or FM radio broadcasts. After a power failure the radio will then set its clock the next time
that you turn on the radio in DAB or FM mode. Alternatively you may specify that the time is
not automatically updated. In this case the clock must always be set manually after a power
interruption.
With your radio switched on, press and hold the Menu button to access the menu for the
current mode.
Press the Folder Up or Down buttons until 'System settings' is highlighted on the display. Press
the Select button to enter the system settings menu.
Press the Folder Up or Down buttons until 'Time/Date' is highlighted on the display. Press the
Select button to enter the time setup.
Press the Folder Up or Down buttons until 'Auto update' is highlighted on the display. Press the
Select button to enter the auto-update menu.
Press the Folder Up or Down buttons to choose an update option from 'Update from DAB',
'Update from FM', 'Update from Network' or 'No update' as required. Press the Select button to
confirm your choice. The radio will then exit to the previous menu display.
.
2.
.
.
5.