CANOGA PERKINS 1500 Domain Management Module - Manual (Page 11)

EdgeAccess Universal Chassis System
Chapter 2
Hardware Installation and Functions
This section describes how to install the DMM in the UCS Model 1000.
Setup and Installation
The DMM is installed in the UCS 1000 Chassis in the top half of slot 0 at the factory. Occasionally,
you may need to install a DMM in a UCS 1000, if ordered separately. The DMM is always installed
in the top half of slot 0. To install the DMM, see Figure 3 and follow these steps:
1. If multiple chassis will be linked, set up the chassis ID numbers. For details on setting the
Chassis ID switch on each backplane, see the Universal Chassis System UCS 1000 User Manual.
2. Set SW4 to FD for full duplex or HD for half duplex Ethernet.
3. Set the MDX/MDI switch to MDI for a straight through cable or to MDX for a crossover cable.
MDX/MDI Switch
SW4
Figure 3. SW4 for Full Duplex (FD) or Half Duplex (HD) Ethernet and MDX/MDI Switch
4. Insert the DMM in the top half of slot 0, pushing it firmly into the connector. Do not force it.
5. Hand-tighten the captive screws to secure the DMM in the chassis.
Note: The DMM is hot-swappable and can be inserted or removed at any time without affecting
data transfer in other modules.
6. If the chassis power is off, switch on the DC power supply(s) for the chassis or plug in the AC
power supply(s). The DMM receives power through the backplane. During the power-on self-
test, all LEDs light amber.
7. At the end of self-test, check for these LED conditions:
• STA lights green
• ACT, LNK, and Rx may be green or off, depending on current management activity
Model 1500 Domain Management Module 2-1