CANOGA PERKINS 1500 Domain Management Module - Manual (Page 36)

EdgeAccess Universal Chassis System
To access the Module Menu, follow these steps:
1. From the DMM Main Menu, type 4 , or "Manage or access a specific Module," and press
<Enter>.
2. At the prompt, type the Chassis/Slot numbers for the module, such as " 1/4 ," for Chassis 1
and Slot 4, and press <Enter>. The Module Menu appears.
3. At the prompt, type the number for one of these options and follow the prompts on the
screen:
• Name the Module: Enter a string of up to 15 characters
• Reset the Module: Reboot the module, load the firmware stored in the active flash
memory, and reset counters, but retain the configuration information; follow the prompts
on the screen
• Reset and Switch Firmware on the Module: Reboot the module and load the alternate
firmware stored in the previously inactive flash memory; follow the prompts on the
screen
• Access User Interface: Opens the Main Menu for the module
4. To return to the Main Menu, press <Esc>.
Copy or Restore the DMM Configuration
You can make a copy of the DMM configuration that can be restored to the same DMM or
copied, as a "gold DMM," to another DMM that will use the same configuration. Use FTP to
move the file between the target PC and the DMM. To back up the DMM configuration, follow
these steps:
1. On the target PC, start an FTP session and verify that folder CONFIG is on the PC.
2. From the target PC where you will store the configuration, type these commands:
bin
cd CONFIG
get ndmm.cfg
You can open the file in a text editor to modify parameters as needed, then save it with another
name. The new name must conform to the 8.3 format "ndmmxxxx.cfg" where xxxx can be up to
four alphanumeric characters; the name is not case-sensitive. Appendix B lists the parameters
with default values.
To restore the DMM configuration to the same DMM or a different DMM, follow these steps:
1. From the target PC where you store the configuration, type these commands:
bin
cd BURNING
put ndmmxxxx.cfg
2. To update the configuration to include changes made since the configuration was backed up
or to make changes needed to use the configuration on a different DMM, go to the specific
procedures in this manual.
3-24 Model 1500 Domain Management Module