Dynon Avionics EFIS-D60 Installation Guide - Manual (Page 20)

Instrument Installation
Panel Location and Mounting
The diagram below shows the outside dimensions of the front bezel of the EFIS-D60. Note that
the instrument and tray extend about 4.5” behind the panel, and the supplied harness extends
three inches more. Use the dimensions (in inches) found on the diagram to plan for the space
required by the instrument. Take the following considerations into account when selecting a
mounting location for the EFIS-D60.
Avoid placing the instrument near heater vents or any source of extremely hot or cold air. Keep
in mind that the air surrounding the EFIS-D60 during operation may be no warmer than 50
°C.
Plan a panel location that allows convenient viewing of the instrument with no obstruction.
When flying straight and level, the panel angle from vertical may not be greater than +/- 30
degrees. The unit must be aligned as close as possible with the longitudinal and lateral axes of
the aircraft. The firmware supports an adjustment for panel tilt, but not for mounting errors in
yaw or roll. Correct attitude performance depends on mounting the EFIS-D60 square with the
direction of flight.
To mount the EFIS-D60, you must make a rectangular cutout in your panel. Ensure that the
dimensions of the cutout are: 6.780” wide and 4.750” tall. Place the D100-series mounting tray
behind the cutout. Secure it to your panel in whatever way you desire. Riveting it to the panel is
ideal, but drilling holes for mounting screws and nuts will work as well. You may cut off 2
horizontal or vertical tabs from the mounting tray to minimize the space taken up behind the
panel. Upon securing the mounting rack to the back of your panel, slide the EFIS-D60 into it.
Use the included 7/64” Allen wrench to secure the mounting screw (at the bottom left of the
front bezel) into mounting rack. At your discretion, you can also screw a #6-32 screw into the
back of the mounting rack on the opposite side. This screw should penetrate into the instrument
no further than ¼”.
3-8 EFIS-D60 Installation Guide