Dynon Avionics EFIS-D10A Installation Guide - Manual (Page 26)

Instrument Installation
Connecting Static & Pitot Lines
3-14 EFIS-D10A Installation Guide
The AOA, pitot, and static ports on the back of the
EFIS-D10A are equipped with 1/8” NPT Female
fittings. To attach your pitot and static lines to the
back of the EFIS-D10A, you must use standard 1/8”
NPT Male fittings at the end of each of the lines.
The EFIS-D10A’s attitude calculation
requires either airspeed (from pitot
and static) or GPS data. To ensure
proper operation, at least one of these
data sources must be available. We
recommend the EFIS-D10A be
connected to pitot and static systems
in all installations.
To install, simply connect your static and pitot
sources to the EFIS-D10A, T’ing off of existing
lines if performing a retrofit. View the following
back view diagram the placement of your pressure
lines.
Use two wrenches to both hold the brass fitting on the EFIS-D10A and secure the mating
pressure line fittings to the corresponding locations on the back of the EFIS-D10A. Do not over-
tighten or allow the brass fittings to rotate.
If you purchased Dynon’s AOA pitot tube, note that it has pitot and AOA ports on it, but not
static. You will need to provide your own source of static pressure for the EFIS-D10A and any
other instrument in your panel which requires it.
AOA
Pitot
Stati
Static