Panasonic Portable CD-Rom Player KXL-810A - Manual (Page 15)

Preparation
■ Connection with Zip or Jaz (for Windows ® 95 * only):
You can connect the Zip or Jaz and your computer with PCMCIA card slot using the
supplied interface card and cable. The interface cable supplied with the player has a
different connector than required by your Zip. The SCSI changer adaptor will allow the
interface cable to connect to your Zip. If necessary you can connect the player and Zip or
Jaz using a commercial SCSI cable. For further information, refer to your Zip or Jaz
manual.
Example connecting with Zip or Jaz (the player is also connected)
m
SCSI changer
adaptor
(not supplied)
[D-sub 25 pin to half
pitch 50 pin (pin type)]-
Interface card
(supplied)
----- Zip
I I r 1
— D-sub
L---------- J
25 pin
t
n
t
I—I
Interface cable
(supplied)
Player
<D
■a
0)
0)
- Half pitch 50 pin 5'
(pin type) 3
SCSI cable
(not supplied)
Interface card
(supplied)
Interface
cable p
(supplied) I
“"«-I — Jaz
^t—K _ . . ..w-
n Half pitch
—-50 pin
(pin type)
j— Player
Half pitch 50 pin
(pin type)
SCSI cable
(not supplied)
Notes:
•When connecting Zip or Jaz only to the computer;
— set the terminator of Zip or Jaz to "ON”.
•When connecting the computer, Zip or Jaz and player;
— for proper data transfer, set the terminator of Zip or Jaz to "OFF” and of the
player to "ON” (t^ P. 36).
— power from the computer (osr* P. 29) cannot be supplied when connected with
Zip or Jaz. Use the AC adaptor, alkaline battery or rechargeable battery.
— the supplied interface card allow connecting only one unit of Zip or Jaz between
the computer and the player.
— do not use the same SCSI ID number for both the player and Zip or Jaz.
* Microsoft® Windows® 95 operating system (hereafter Windows 95).
15