Panasonic Portable CD-Rom Player KXL-810A - Manual (Page 31)

Troubleshooting
If trouble occurs, check the following points before returning the player for service.
Trouble Possible Cause Solution
Your computer
does not
recognize the
The AC adaptor is not plugged
into the outlet or DC IN jack
correctly.
Plug the AC adaptor correctly
{(ET P. 13).
player, or does not
function properly.
The Auto Protect function of AC
adaptor is working.
Disconnect the AC adaptor and
connect it again after 2—3
minutes.
The alkaiine batte ries/battery
case or rechargeable battery
are/is not installed correctly, or
dead.
install the alkaline
batteries/rechargeable battery
properiy, charge the recharge-
abie battery or replace with new
batteries {(^ P. 25—28).
■ For notebook/desktop computer with PCMCIA card slot user:
The computer has not been set
up yet.
Set up the computer ( iep “ P. 14).
The interface cable or card is
not connected to the player or
to the computer properly.
Properiy connect the interface
cable or interface card
((ET P. 14).
The interface cable pin is bent
or broken.
Consuit your deaier (or contact
Panasonic Service Center at
1 -800-PANA-SYS for users in
continental United States).
When using under Windows 95,
the player is turned off. Reset the computer or refresh
the device manager (isr’ P.20).
Refer to the “Help” file for
detailed information (a^ P. 7 in
Setup Manual).
When the power from the
computer is used, the player’s
terminator is set to ON. Set the terminator to OFF
(¡^ P. 36).
When the power from the
computer is used, the
computer’s battery is low. It is recommended to use the
AC power for the computer
(05^ P. 12, 29).
When the power from the
computer is used, power supply
capacity of the computer is not
sufficient. Use the AC adaptor, alkaline
batteries or rechargeable
battery ((^ P. 12, 13, 25-28).
c
w
d '
ta
(D
o Tl
c 2
(D S
3- <D
O 0)
<t> 3
0) &
CL?
□
o
c
O'
to
(Continued)
31