Panasonic Portable CD-Rom Player KXL-810A - Manual (Page 20)

Using the Player with Computer
Make sure that all the necessary preparation is done (i^P. 13—16, 36) and your computer
has been set up properly Setup Manual).
■ Using with the supplied interface card:
Turning on the computer automatically turns on the player.
(T)
Turn on the computer,
(2) Insert a CD P. 17).
Using with the SCSI board:
Slide the power switch to turn
on the player (isr P. 18).
@ Turn on the computer.
@ Insert a CD ( d ^ P. 17).
Notes:
•When POWER/BUSY lamp is blinking:
—Do not open the disc cover.
—Do not press .
— Do not disconnect the interface card.
— Do not turn off the player.
— Do not remove the AC adaptor when it is used.
— Do not remove the alkaline batteries or rechargeable battery when one of them
is used.
Otherwise, your computer may hang up. If this happened, reset your computer.
• If is displayed on the player’s display when using the player with the alkaline
batteries, rechargeable battery or power from the computer, quickly connect the AC
adaptor. Otherwise your computer may hang up.
•If the interface card is used to connect the player and your computer under Windows
95, the computer cannot recognize the player when the player is turned off. To use
the player again, reset the computer, or refresh the device manager after turning on
the player. Refer to the “Help” file for detailed information (tsr P. 7 in Setup Manual).
•When using the alkaline batteries, rechargeable battery or power from the computer,
you may notice the data transfer speed slows and access time increases.
20